Clamped 51mm gutter vac poles

Every kit starts with a blue fibreglass base and second section, with black carbon sections above them. Every section is 152cm, so the pole packs down short enough to travel upright in the van.

The sections are clamped rather than push-fit, so nothing creeps under load, and the 51mm fitting goes onto any 51mm gutter vacuum system.

The silicone 135° neck is the flexible one. It comes with two jubilee clips and a carbon adapter.

The carbon necks are rigid, so the nozzle goes where you point it at full extension. The 135° neck is the one supplied with the carbon-neck kits; the 45° is a shallower angle, for getting into a gutter from closer to the wall.

The base, second and carbon sections are each sold on their own, so you can add reach to a kit you already run, or replace a damaged section rather than buy the whole pole again. (The blue base section is out of stock at the moment.)

Necks and nozzles are sold separately too, in aluminium and carbon fibre.

A gutter pole works at roof line, where the service cables are. The insulated lower sections are a last line of defence, never a reason to work near overhead lines. Read our overhead power line safety guidance before you extend.